Marantz SR4320N Uživatelský manuál Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 172
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
7
ENGLISH
CONNECTIONS
CONNECTING SPEAKERS
Connecting speaker wire
1 Strip away approx. 3/8 inch (10 mm) of wire insulation.
2 Twist the exposed wire ends very tight to prevent short circuits.
CAUTION
Be sure to use speakers with the specified impedance shown on
the rear panel of this unit.
To prevent damage to circuitry, do not let
the bare speaker wires touch each other
and do not let them touch any metal part
of this unit.
Do not touch the speaker terminals when
the power is on. It may cause electric
shocks.
Do not connect more than one speaker cable to one speaker
terminal. Doing so may damage this unit.
Note:
Be sure to connect the positive and negative cables for the speaker
properly. If they are miss-connected, signal phase will be reversed
and the sound quality will be corrupted.
3 Loosen the knob by turning counterclockwise.
4 Insert one bare wire into the hole in the side of each terminal.
5 Tighten the knob by turning clockwise to secure the wire.
System B
Right Left
System A
Right Left
VIDEO
OUT
IN
REMOTE
CONTROL
OUTIN
MONITOR
OUT
DVD
IN
DSS
IN
VCR
GND
AUDIO
R
OUTIN
OUT
IN
OUTIN
MAIN
IN
DVD
IN
DSS
IN
PHONO
IN
VCRTAPECDR
/
MD
FM
(
75
)
GND
AM
ANTENNA
L
CD
IN
PRE
OUT
AC IN
SYSTEM A
LR
SYSTEM B
RL
SPEAKER SYSTEMS
SYSTEM A : 4
-
16 OHMS
SYSTEM B : 4
-
16 OHMS
SYSTEM A
+
B : 8
-
16 OHMS
10 mm
SR4320N 01 ENG 03.11.28, 2:51 PMPage 7 Adobe PageMaker 6.5J/PPC
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 171 172

Komentáře k této Příručce

Žádné komentáře